Keeps the pulley from turning while you are removing the pulley nut.
This tool only works on our pulleys with a hex on them such as the 6RLS pulleys, but it will only work on the 6RLS pulley if you are using it for a Lotus application.
Per a GM mechanic's publication; "use an open end wrench on the idler pulley lug to relieve belt tension for belt removal." But we found the lug on the casted idler mount has too much taper for a wrench to fit properly...
We prefer to use our custom Belt Tension Relief Tool that makes the job a snap.
For use with the Saturn Ion Redline.
This complete replacement kit includes one allen wrench, five screws and a re-usable plastic plug for the supercharger shaft M8 hole.
Need this in conjunction with the installation/puller tool in order to remove our Qwikchange Hubs.
Inside diameter of horseshoe section: 1.4" (35.7mm)
Thickness of the plate: 1/4"
M90/M112 Puller & Installer Tool
M62/M45 Puller & Installer Tool
Main Rod Kits Replacement Main Rod Kits for all brands of puller tools:
There is an enormous load placed on the M8 screw during a pulley swap. Brighton-Best fasteners are among the finest available and hold up to the punishment.
Pulley Boys recommend using anti-seize on all threads and fresh M8 hardware for every pulley swap. Sold in sets of six, one washer is supplied with every M8 screw.
This will repair the M8 screws used in the puller kit without having to buy another complete puller tool.
This may not fit the 4.0L Toyota TRD Superchargers, please check that you have 1/2" clearance behind the snout to allow for the horseshoe shape of the puller tool.
Removes press fit pulleys from any M112 or M90 Eaton Supercharger.
You don't need this tool for keyed pulleys.
If you are installing or removing one of our Qwikchange hub assemblies you will also need our qwikchange hub removal plate in order to remove it successfully.
For Instructions on using this tool please see our help section found here.
Dimensions of horse shoe piece:
Removes press fit pulleys from any M62 or M45 Eaton Supercharger.
Not needed for keyed pulleys.
If you are installing or removing one of our Qwikchange hub assemblies you will also need our qwikchange hub removal plate in order to remove it successfully.
For Instructions on using this tool please see our help section found here.
Dimensions of horse shoe piece:
Per a GM mechanic's publication; "use an open end wrench on the idler pulley lug to relieve belt tension for belt removal." But we found the lug on the casted idler mount has too much taper for a wrench to fit properly.
We prefer to use our custom Belt Tension Relief Tool that makes the job a snap.
For use with the Chevy Cobalt SS Supercharger Kits
This complete replacement kit includes one allen wrench, five screws and a re-usable plastic plug for the supercharger shaft M8 hole.
This is for our Nissan qwikchange kit, these screws are too long to fit any non-Nissan qwikchange kit.
