Eaton M90/M112 Pulley Puller & Installation Tool
This may not fit the 4.0L Toyota TRD Superchargers, please check that you have 1/2" clearance behind the snout to allow for the horseshoe shape of the puller tool.
Removes press fit pulleys from any M112 or M90 Eaton Supercharger.
You don't need this tool for keyed pulleys.
If you are installing or removing one of our Qwikchange hub assemblies you will also need our qwikchange hub removal plate in order to install/remove it successfully.
For Instructions on using this tool please see our help section found here.
Dimensions of horse shoe piece:
- Inside Diameter for accommodating snout: 2.61"
- Thickness: 0.5"
Removes Joe Gibbs Style Supercharger Pulleys
Removes all GM Series II & III 3.8L V6 Supercharged Vehicles Including but not limited to:
Buick Century 1997-2002
Buick LeSabre 1996-1999
Buick Park Avenue 1996-2004
Buick Regal 1996-2004
Buick Riviera 1996-1999
Chevy Impala SS 2004
Chevy Monte Carlo SS 2004
Oldsmobile Eighty-Eight 1996-1999
Oldsmobile LSS 1996-1999
Oldsmobile Regency 1996-1999
Pontiac Bonneville 1996-2003
Pontiac Grand Prix 1997-2006